OILER CLAMP SYSTEM
£ 9.75
NEW FROM MODELBOATBITS OIL LUBRICATION CLAMP UNIT EASY TO FIT TO EXISTING TUBES 3/16"(4.76mm), 1/4" (6.35mm), 6.0mm & 5/16"( 8.0MM )
 
NEW FROM MODELBOATBITS PROPSHAFT OILER CLAMP KIT

MADE FROM SOLID CAST BRASS 

TO SUIT 1/4" (6.35MM TUBE )- WILL ALSO FIT 3/16"(4.76mm) & 6.0MM TUBE USING REDUCER SLEEVE ) 
                5/16" (8.0MM TUBE)

NOTE: 1/4" VERSION COMES WITH A REDUCE SLEEVE TO ENABLE
              FITTING TO POPULAR SLIMLINE SHAFTS ( 6.0mm TUBE ) AND ALSO 3/16" (4.76mm) TUBE
 
SIMPLE TO INSTALL:
1  REMOVE INNER PROPSHAFT
2  SET CLAMP ONTO TUBE IN SUITABLE POSITION
3  PASS DRILL DOWN RISER TUBE UNTIL DRILL GOES THROUGH BRASS TUBE
4  CONNECT SILICONE TUBE THEN INJECT OIL USING SYRINGE PROVIDED 
5  CAP TUBE OFF USING PLUG PROVIDED
  
KIT INCLUDES:

1 off   BRASS CLAMP
1 off   SILICONE TUBE/DUST CAP
1 off   OILER SYRINGE
1 off   SYRINGE CAP
 
TIP: PUT A OF THICK GREASE ON TIP OF DRILL TO RESTRICT
       SWARF FROM DRILL PASSING INTO MAIN SHAFT TUBE  

NOTE: USE PLUMBERS PTFE TAPE TO GIVE GREATER SEAL ON PITTED OR UNDERSIZE TUBES
People Who Bought This Also Bought:
 
  • propshaft grease
    WATER RESISTANT PROPSHAFT GREASE LOW DRAG MOLY-FORTIFIED LITHIUM GREASE 20ml SYRINGE
    Price £4.25
Write a review